PAGE 1. ADEMCO VISTA SERIES VISTA-20P / VISTA-20PSIA VISTA-15P / VISTA-15PSIA Security Systems Programming Guide K5305-1PRV5 10/04 Rev. PAGE 2. TO ENTER PROGRAMMING MODE (using an alpha keypad connected to the control): A. POWER UP, then press [ ] and [#] at the same time, within 50 seconds of powering up (this method must be used if 98 was used to exit program mode).. ADEMCO VISTA SERIES VISTA-20P / VISTA-20PSIA VISTA-15P / VISTA-15PSIA Security Systems Programming Guide K5305-1PRV5 10/04 Rev. A Downloaded from www.Manualslib.com
To add a new sensor to the Honeywell ADEMCO VISTA-20P: 1. Mount the Sensor: Secure the sensor in the desired location, such as a door or window. 2. Wire the Sensor: If it's a wired sensor, connect it to the appropriate zone terminals on the control panel. 3. Enter Programming Mode: - Enter the installer code followed by `800` to access programming mode.. TO ENTER PROGRAMMING MODE (using an alpha keypad connected to the control): A. POWER UP, then press [ ] and [#] at the same time, within 50 seconds of powering up (this method must be used if 98 was used to exit program mode). OR B. Initially, key: Installer Code (4 + 1 + 1 + 2) plus 8 + 0 + 0. PROGRAMMING MODE COMMANDS